My current network setup is as follows.
Internet → (wired ethernet 1)
(also wired ethernet 2) → to TX2 board
My PC is installed Ubuntu 16.04
After installing Jetpack via terminal with ./JetpPack-L4T-3.0-linux-x64.run
TX2 board installed and successfully boot however no internet connection.
On TX2, if I check ifconfig, there is no IP address leased from my PC
Internet on my PC work just fine and IP address on is set as 10.0.0.1
Before installing Jetpack, internet sharing worked just fine with above setup.
What would have messed up the whole dhcp thing? Any suggestions?
following is what I got from my PC when try ifconfig
$ ifconfig
eno1 Link encap:Ethernet HWaddr *************
inet addr:10.0.0.1 Bcast:10.0.0.255 Mask:255.255.255.0
inet6 addr: ************* Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:465 errors:0 dropped:0 overruns:0 frame:0
TX packets:516 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:96376 (96.3 KB) TX bytes:71499 (71.4 KB)
Interrupt:20 Memory:f7c00000-f7c20000
enp5s0 Link encap:Ethernet HWaddr *************
inet addr:##.##.##.## Bcast:##.##.##.## Mask:255.255.255.0
inet6 addr: ************* Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:50960 errors:0 dropped:2719 overruns:0 frame:0
TX packets:34198 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:19614684 (19.6 MB) TX bytes:3283312 (3.2 MB)
Memory:f7900000-f79fffff
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:1235 errors:0 dropped:0 overruns:0 frame:0
TX packets:1235 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:102721 (102.7 KB) TX bytes:102721 (102.7 KB)